Tag: taxi

  • Taxi: rails and holes

    Taxi: rails and holes

    I’ve drilled all the holes that go all the way through the playfield. It was anxious work. Also put on all the black rails. Another long task was fixing all the lamp sockets. Dude who cleared the playfield shot clear into them so many weren’t working. All clean now. I’m going to start populating the…

  • Taxi speaker panel mod

    Taxi speaker panel mod

    Speaker panel cut and t nuts back in the right place, everything painted black. I think I’m eventually going to go all the way with this one and put in a crossover and an 8″ woofer for the cab and a separate volume for the backbox. For now just speaker replacement here.

  • Taxi: speaker panel and interconnect board

    Taxi: speaker panel and interconnect board

    Disassembled the speaker panel to get it ready for replacement speakers on both sides. It’s worth it. Also pulled the interconnect board to fix the GI pins and found a really burnt area under the resistors. Going to fix that too now! Unfortunately this probably means another round of parts to buy but I’m in…

  • Taxi: working down the list

    Taxi: working down the list

    Checking off Taxi tasks like crazy. From here on out, the job is assembly. Pretty sure i have ALL the parts aside from a few bulbs, rubbers, and post sleeves. I’ll find more stuff i’m missing along the way but it’s so damn exciting to have the end in sight. 

  • “just one more thing”

    “just one more thing”

    Just one more. Just one more thing. Just this one last thing… 3am.  The pins in the photo mark the through holes that were covered by the overlay. Normally i’d say i have about 5-10 hours left with a machine at this stage but in this case with the new clear coat and overlay obscuring…

  • Taxi metals, polished up

    Taxi metals, polished up

    Finished wet sanding all the steel guides for Taxi. Steps: 220 -> green scrubby -> 400 -> 600 -> 800. Some didn’t get all steps (only the worst got 220), but it’s still a lot of elbow grease. Will polish the most visible ones a bit further with Mother’s mag polish but I’m really happy…

  • Taxi restore: It’s all over under there

    Taxi restore: It’s all over under there

    The underside of the playfield is 99% complete. All the mechs are in and wires soldered. Gonna clean and wax the playfield before completing the flipper installation. I’ve taken this machine further than any other restore so far, though I won’t be doing much to the outside of the cabinet even though it’s a bit…

  • Microswitch nightmares

    Microswitch nightmares

    Took me 45 minutes to reinstall two microswitches on Taxi tonight. Actually, it took me 40 minutes to install one microswitch and 5 for the other. Hopefully the other 6 go faster!

  • Taxi: under playfield clean-up

    Taxi: under playfield clean-up

    I’ve basically cleaned everything under the playfield but the light sockets. Ordered some parts I needed to finish the pops, and in the meantime I’ve been cleaning metal from the cabinet (grills, etc). I’ll actually be repopulating by next week! Also, I love my space.