Novus 2 and 1 on all the flat plastics. I need to assemble the connected plastics and the decorative mini posts and figure out where I am potentially missing posts. I was able to attach one of the small plastics and it was quite satisfying.
Only plastic parts left to clean are the spinout ramp and the two clear ramps. Then 4 wire ramps and that’s THE END OF BUYING PARTS.
I reviewed the schematics and determined how I should wire up the replacement speaker wiring with crossover and volume mix control. It took a bit of digging and ultimately comparing schematics from shadow (wpc era matching the tutorial I followed) with the ones from Taxi. The only mystery is which set of outputs goes to the cabinet and which to the backbox. I’m not in any rush to do this because it’ll be fine without it, but it’s good to know the way forward and feel confident about what I’ll be doing when the time comes.
As long as I don’t totally screw something up or find I’m missing a hard to find part, I could be playing by Friday. Yikes! I’m cautiously optimistic.
Leave a Reply